Place on the red Plate 2x10 the following red pieces: red Plate 1x2, red Brick 1x2, red Plate 1x2 1 with stud, blue Brick 1x2 with hole. Place red Plate 1x1 on red Plate 1x2 with 1 stud.
Place two yellow Brick 1x1 with Handles on red Plate 1x2. Place Slope Brick 45
2x1 on Plate 1x1. Place blue Brick 1x2 with Axle Hole on slope brick. Place
red Plate 2x1 then blue Brick 1x2 with Hole on top of blue Brick 1x2 with Hole.
Assemble transmission: Axle 6, Yellow Micromotor Pulley, Worm Screw,
Axle Joiner Perpendicular. Transmission fits through blue Brick 1x2 with
Axle Hole. NOT PICTURED: Rubber band stretches between handles (yellow
Brick 1x1 with Handle) and Yellow Micromotor Pulley.
Insert Transfer Gear into Joiner: Axle 3 with Stud, Gear 16 Tooth. May
need to insert one or more Bush 1/2 to stabilize.
Insert Input into Blue Brick 1x2 with Hole: Axle 6, Gear 8 Tooth. May need
to insert one or more Bush 1/2 to stabilize.
Insert Power and Output into two Blue Brick 1x2 with Holes: (same as Input)
When the Input is on, the transmission puls the Transfer Gear away from the
output and the power, and the Power is not transferred to the Output, which
is off. When the Input is off, the rubber band pulls the transmission forward,
engaging the Transfer Gear with the Input and the Output, which is on.